| View previous topic :: View next topic |
| Author |
Message |
Blaize
Joined: 20 Jun 2009
Posts: 1
|
| Posted: Sat Jun 20, 2009 5:44 am Post subject: I need some help with a Hoyt bow. |
|
|
When toghtening/loosening the Hoyt Vulcan do you need to adjust the two smaller screws on either side of the limbs or just the main larger screw in the middle?
Or am I going about this the wrong way enitrely?
Any advice/help would be greatly appreciated
I've attached a photo of a similar Hoyt model
TIA
*I Believe That The Picture Is Of A Hoyt Katera.* |
|
| Back to top |
|
cam69conv
Joined: 22 Oct 2006
Posts: 705
Location: Summit, IL
|
| Posted: Mon Jun 22, 2009 12:36 pm Post subject: |
|
|
| Just a half crank to losen the slide screws up a smidge is all you need. Those are primarily there for limb pocket protection is about it... Dont go running them out. Just a half turn out to losen them up for adjusting then tighten them back down after you adjust limb tension. |
|
| Back to top |
|
cubdriver
Joined: 04 Oct 2009
Posts: 1
Location: AK
|
| Posted: Sun Oct 04, 2009 7:49 pm Post subject: limb bolts |
|
|
| Be sure to loosen the two locking bolts on each end of the riser slightly before tightening or loosening the limb bolts to avoid problems. |
|
| Back to top |
|
| |
