| View previous topic :: View next topic |
| Author |
Message |
iqbal
Joined: 01 Aug 2003
Posts: 5
|
| Posted: Mon Aug 04, 2003 9:38 am Post subject: |
|
|
| I have been reloading for quite sometime but lately i'm having problems,i.e.when i'm decapping the primer the case gets stuck in the die.I'm using RBS carbide dies which do not require lubricating the case but inspite of lubrication the problem exists.Is it the die which may have worn out or what.Would appreciate advice. |
|
| Back to top |
|
PeterM
Joined: 18 Feb 2003
Posts: 40
Location: Sweden
|
| Posted: Thu Sep 04, 2003 8:03 am Post subject: |
|
|
Hi
At what point does the case get stuck? In the bottom point meaning that the whole case is in the tool or when the expander goes back true the calibrated neck? Either way it can be dirt in the tool that causes the case to stick. Take the tool apart and clean it properly. Have you checked the length of the cases before calibrating? Have you checked the tool for damage?
/Peter
|
|
| Back to top |
|
cdhunt
Joined: 27 Jan 2004
Posts: 62
Location: hanover, pa
|
| Posted: Thu Jan 29, 2004 3:10 pm Post subject: |
|
|
| PETERM is correct-dirt is probably the answer--disassebble die and clean with a goo degreaser-acetone-dry with a mop-reassemble and you are good to go |
|
| Back to top |
|
| |
