Well my trip started in Whitehorse Yukon where we flew 2 1/2 hours North to our Goz Lake base camp. We then loaded up our horses and rode for 2 days to our spike camp. Saw several Caribou and a sow grizzly and cub on the way.
We rode up on a young male Grizzly on out 1st day of hunting! Luckily we ran the other way. We hunted several drainages for a couple days only spotting a few small rams and ewes but LOTS of Caribou bulls. On day 3 of the 10 day hunt we found a SHOOTER bull caribou only a mile from spike camp. After a short climb/stalk I dropped him at 100 yards with my Browning A Bolt 30-06. Day 4 found us in a HUGE drainage 12 miles from spike camp. We saw 7 rams that day...all small...several were 3/4 curl 6-7 year olds and one full curl but my guide said he was young and small. We were walking the horses down a step drainage around 8:30pm when we spotted this ram climbing the mountain above us. We ran about 200 yards up the mountain to a large rock to get a better look. Shoot my guide said...330 yards up hill. The 165gr. Nosler Partition did the job. After many pictures and butchering we made it back to camp at 2:45am the next day. We were lucky to tag out because the next 2 days we were weathered in with wind,rain and LOTS of fog. We saw a dozen or more sheep and Caribou bulls on our 2 day ride back to base camp. It was a "TRIP OF A LIFETIME.' The Yukon is the most AWESOME sight I have ever seen. HUGE breath taking mountains and AWESOME hunting! I can't wait to return. They say you NEVER really leave the Yukon....now I know why. Anyone looking for a first class Dall sheep hunt check out Chris's opertation at http://WWW.WIDRIG.YK.CA. You won't be disappointed!
Here is a very handy and effective device I use to dispense corn with - but it could also be used to dispense any other seed or deer feed.
I had an old feeder that had a failed motor... I made a set of brackets to attach the feeder to the rear of the 4 wheeler - the lower one encircles the feeder and has a forward section with holes drilled in the outer ends of the bracket... these holes align with two 5/16" bolts that drilled into the rack of the 4 wheeler.
The upper bracket is an "L" shaped...